Satisfied with the products supplied by Ceramed
Yes, burrs can be removed from even very minute parts.
No, A small fillet and chamfer appears after the process due to material removal
Yes, pit marks and dent marks can be removed depending upon components structure and media reach to these areas in the component.
Yes, it can be done. However, the lowest diameter hole to be polished should not fall below 4-5mm.
The internal thread damage can certainly be controlled whereas the external threads are affected by the Abrasive media.
As cost for carrying out the job work primarily requires to ascertain many parameters. We shall not arrive at any desired answer regarding the costing process time and consumables usage. Trials must be conducted to freeze these parameters and arrive at a desired solution.
The same can be confirmed only after conducting trials.
Since the machines we manufacture are made-to-order, including the imported motor installed, we will require about 4-6 weeks from our Customers Order date.